FIRMWARE REVISION UPDATES

The following sequence is necessary to prepare the UPA for upgrading.
     - Hold down Capture Button
     - Power up
     - Wait for 2 flashes
     - Wait for 5 flashes
     - Let go of Capture Button
     - Run the MM software supplied
Execute the Memory Manager Software supplied by ORION.  You have the option of placing the software into primary memory or secondary memory.  Having two separate memories allows you to select one of two versions of the firmware depending on the application.
If you power up normally, the primary memory is used for operation.  If you wish to use the secondary memory then do the following on power-up.
     Secondary Slot Software
          - Hold down Capture Button
          - Power up
          - Wait for 2 flashes
          - Let go of Capture Button
    Primary Slot Software
          - Runs on power-up